Bush Hog 225 Manuel d'utilisateur

PAMIPRAIRIE AGRICULTURAL MACHINERY INSTITUTEALBERTAFARMMACHINERYRESEARCHCENTREA Co-operative Program BetweenEvaluation Report No. E3580BPrinted: May,

Page 2BUSH HOG CP-7815 CHISEL PLOW MANUFACTURER: Bush Hog Equipment Ltd. P.O. Box 328Imperial, SaskatchewanS0G 2J0DISTRIBUTOR: Bush Hog Equipment Ltd.

Page 3NOTE: This report has been prepared using SI Units of measurement. A conversion table is given in APPENDIX III. GENERAL DESCRIPTION The Bush H

Page 4front sweeps to penetrate only 20 mm (0.8 in) deeper than the outer rear sweeps. The Bush Hog CP-7815 followed gently rolling fi eld contours v

Page 5FIGURE 8. Sweep Pattern (305 mm Shank Spacing). Care should be taken to install proper length bolts to prevent thread damage. The 225 mm (9 in

Page 6have ample power reserve to operate the Bush Hog CP-7815 in the stated conditions. TABLE 2. Tractor Size (Maximum Power Take-Off Rating, kW) to

Page 7FINISHING HARROWS Locking Collars: The locking collars used to adjust the height and pressure of the harrow bars slipped during operation. Freq

3000 College Drive SouthLethbridge, Alberta, Canada T1K 1L6Telephone: (403) 329-1212FAX: (403) 329-5562http://www.agric.gov.ab.ca/navigation/engineeri