Bush Hog 865H Manuel de l'opérateur télécharger pdf (Page 28)

5-4 BAND INSTALLATION

A. Raise wings to the transport position and in-

stall transport lock pins. Bands will be installed to

underside of deck (In the same arrangement as the

rear chains in Figure 5-20).

B. Align holes on outer wing band with holes in wing

skid. Install 3/8” x 1” bolt and nut to support band.

C. Align holes on bands with those on wing. Insert

carriage bolts through deck and bands. Secure with

lockwashers and nuts. Secure bands together using

angle splice fasteners provided.

D. Tighten all nuts.

E. Align holes on center band with those on cutter

center section. Insert carriage bolts through deck and

bands. Secure with lockwashers and nuts.

F. Tighten all nuts.

5-5 FRONT BELTING

FOR NON-AGRICULTURAL USE, OSHA,

ASAE, SAE AND ANSI STANDARDS

REQUIRE THE USE OF CHAIN GUARDS OR

OTHER PROTECTIVE GUARDS AT ALL

TIMES. BUSH HOG STRONGLY RECOM-

MENDS THE USE OF SUCH GUARDS FOR

AGRICULTURAL USES AS WELL, TO RE-

DUCE THE RISK OF PROPERTY DAMAGE,

SERIOUS BODILY INJURY, OR EVEN DEATH

FROM OBJECTS THROWN OUT BY OR

FROM CONTACT WITH THE CUTTING

BLADES.

WARNING

Figure 5-22 Belting Installation

Belting

Support

Cutter Deck

5-6 HYDRAULIC PLUMBING (Pages28 & 29)

The hoses should be routed down the right hand side

strong back through the loops and under the cross rod

at the back of the tongue hitch plates and then up

through the hose holder rod. There is one longer

hose and it should be connected to the left section fold

cylinder and routed under the axle lift cylinder before

routing through the loops. (Figure 5-23)

5-7 BAFFLE INSTALLATION

Refer to Figure 5-24 for arrangement of the various

baffle components. Fasten the baffle parts to the un-

derside of the cutter using (17) 1/2” x 1-1/4” Grade 5

carriage bolts, lockwashers and nuts and (4) 3/8” x 1-

1/2” Grade 5 carriage bolts, flatwashers, lockwashers

and nuts..

NOTE: The carriage bolts must be inserted so that

the bolt head will be on the hinge side with the nut

on the blade side. If the bolts are not correctly in-

stalled, they will contact the hinge area when the wing

folds down 22°.

Figure 5-23

Hydraulic Hose Routing

A. Compare each piece of belting and supports to

Figure 5-20 to determine location for installation.

B. Place belting between two supports. Align holes

in belt and support with those on cutter. Insert car-

riage bolts through deck, supports and belting. Se-

cure with lockwashers and nuts. (Figure 5-22)

C. Tighten all nuts.

Figure 5-21

Deck

Band

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

Bush Hog 865H Manuel de l'opérateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Pelle compacte Bush Hog 865H