Bush Hog RTC Spécifications télécharger pdf (Page 9)

SPECIFICATIONS

SECTION II

PREPARATION FOR USE

2-1 ATTACHING TO TRACTOR

A. Attach tiller to tractor 3-point hitch per tractor

operator’s manual. Do not attach driveline at this

time.

NOTE

Due to the many variations in tractor/implement hitch

points and corresponding differences in distances

between tractor PTO shafts and implement input

shafts, drivelines may need to be shortened as

described in the following steps:

B. Raise and lower tiller to determine position

with shortest distance between the tractor PTO shaft

and gearbox input shaft. Shut down tractor, leaving

tiller in position of shortest distance. Securely block

tiller in position.

C. Pull driveline apart. Attach outer (female) sec-

tion to tractor PTO shaft. Pull on driveline section to

be sure that yoke locks into place.

D. Hold driveline sections parallel to each other

to determine if it is too long. Each section should end

approximately 3 inches (76mm) short of reaching

universal joint shield on opposite section. If too long,

measure 3 inches back from universal joint shield

and mark on opposite section. (Figure 2-1). Do this

for both sections.

WARNING

TO AVOID SERIOUS INJURY OR DEATH:

NEVER STAND BETWEEN TRACTOR

AND TILLER WHILE TRACTOR IS BEING

BACKED TO HITCH.

WARNING

TO AVOID SERIOUS INJURY OR DEATH:

ADDITIONAL TRACTOR FRONT BAL-

LAST MAY BE NEEDED FOR STABLE

OPERATION AND TRANSPORT OF THE

TILLER. SEE TRACTOR OPERATOR’S

MANUAL FOR RECOMMENDED WEIGHTS.

Figure 2-1

E. Raise and lower tiller to determine position

with greatest distance between PTO shaft and gear-

box input shaft. Shut down tractor leaving tiller in

position of greatest distance. Securely block tiller

in position.

F. Hold driveline sections parallel to each other

and check for minimum 6 inches (15cm) overlap.

(Figure 2-2) If driveline has been marked for cutting,

overlap will be the distance between two marks. If

driveline has less than minimum overlap, do not use.

Contact authorized Bush Hog dealer.

Figure 2-2

Minimum Overlap

Model RTC40 Model RTC48

Tilling width 39-1/4” 48-1/4”

Overall width 44” 53”

Offset 4” N/A

Blades per flange 44

No. of flanges 45

Hitch 3-point Cat. I only

PTO speed 540 rpm

Rotor speed 250 rpm

Max. recommended HP 24

Max. till depth 6”

Gearbox oil capacity 17 ozs.

Weight 308 lbs. 335 lbs.

Driveline protection Slip Clutch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Bush Hog RTC Spécifications Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Bush Hog RTC